Rotary Seals

Ceetak offer a wide range of seals for use in rotary applications; these range from traditional single or double lipped elastomeric configurations to PTFE based designs – or a combination of both.

 

Rotary shaft seals work by squeezing and maintaining the lubricant in a thin layer between the lip and the shaft. Sealing is aided by the hydrodynamic action caused by the rotating shaft which creates a slight pump action.

 

The amount of frictional heat that is generated in an application is dependent on a combination of many operating parameters; shaft surface, internal pressure, operating speed, lubricant type, lubricant levels, lip geometries and lip materials are just a few conditions that should be considered, and it is important to note that these conditions are interactive.

 

It’s imperative to have an understanding of rotating shaft seals when selecting the correct solution for each application in order to reduce the meantime between failure of rotating equipment.

Our rotary shaft seals are available in many different materials. Rotary shaft seals with elastomeric based lips include Nitrile (NBR), Fluorocarbon (FKM), Carboxylated Nitrile (XNBR), Hydrogenated Nitrile (HNBR), Ethylene Propylene (EPDM), Polyacrylate (ACM), Silicone (VMQ) and Neoprene (CR).

 

There are various different casings available for rotary seals; most common include carbon steel and stainless steel. Depending on application criteria, other case materials include aluminium, zinc-plated cold rolled steel and Hastelloy®. Springs in stainless steel can also be provided.

 

The following types of rotary seal profiles are a basic overview of our range:
• Springless Profiles
• Spring Loaded Profiles
• Dual Spring Loaded Profiles
• Medium Pressure Profiles
• Cassette Seal Profiles
• PTFE FlexiSeal Profiles
• PTFE FlexiLip Seal Profiles
• PTFE FlexiCase Seal Profiles
• V-Ring Profiles
• Elastomer Seals with PTFE Inlaid Lip

Download our brochure to find out more:

 

Rotary Shaft Seals

WHY CHOOSE CEETAK

 

PRODUCTS: Vast product range with extensive selection of materials available for all applications, with specialist approvals for critical markets and applications.

 

ENGINEERING: Application Engineers who are highly skilled and experienced in seal design and material recommendations. Complete design service; from initial enquiry and profile geometry selection, through to tool design for mass production and performance analysis and review.

 

QUALITY: ISO9001:2008, ISO14001:2004, TS16949 and ISO13485 approved manufacturing for quality assured products with supporting processes and documentation to meet customer requirements.

parker_pradifa.png.jpg
Eusga Logo
Toss logo
ropex
PPMA logo