Skip to Content
Skip to Main Menu

Diaphragms

Rubber diaphragm seals offer an ideal sealing solution where an accurate, consistent response is required for changes in hydraulic or pneumatic pressures with zero leakage, low friction, and no lubrication.

Features

Accurate control, zero leakage and no lubrication required

Re-inforced diaphragm materials capable of withstanding high pressure applications

Extensive range of material combinations for manufacture

Complete diaphragm design service from experienced application engineers using the latest 2D/3D design and simulation software

Our Diaphragms

Diaphragms are an excellent seal of choice for a variety of hydraulic and pneumatic applications, and are commonly used as seals in pumps, air brakes, dispensing and metering systems, pressure switches, flow meters, and valves and valve actuators.

We have a broad range of moulding capabilities, with the ability to produce diaphragms from as small as 12mm diameter and over 1000 mm in diameter. We specialise in the design and manufacture of rolling "Top Hat", convoluted and dished diaphragms in single acting or double acting format.

We offer a range of elastomer and plastic diaphragms as well as specialist combination materials such as overmoulded elastomer to thermoplastic diaphragms, and rubber with fabric reinforcement diaphragms.

• Nitrile (NBR)                                                                           • Silicone (VMQ)
• Fluorocarbon (FKM)                                                              • Chloroprene (CR)
• Ethylene Propylene Diene Monomer (EPDM)                   • Polyacryate (ACM)  
• Hydrogenated Nitrile (HNBR)                                              • Perfluoroelastomers (FFKM)

These elastomer materials are available in a single layer or double layer format, bonded with the following fabric materials: 

• Polyamide (Nylon)
• Polyester
• Nomex®
• Vectran™

We also manufacture diaphragms in PTFE for applications that demand materials with high chemical resistance or that require FDA approval or compliance.

For applications where good abrasion resistance and flex durability is required, we can manufacture diaphragms in a range of TPE materials including Hytrel, Santoprene and Polyurethane. These materials offer good tensile strength and do not require fabric reinforcement.

In association with
Member of EUSGA
High Tech NL
Bedford Blues

Contact Us

By submitting this form, you are agreeing our Privacy Policy For more information see our Privacy Policy
Close Menu